Jidé s.a. – Rue des Meuneries 11 – B-4650 HERVE (Belgique) – Tél. +32 87 31.75.12 – Fax +32 87 31.75.11 –
Modul-ART (EN) June 2018
4
USER INSTRUCTIONS
Lighting the fire
Before lighting the fire, clear excess ash.
Do not overcome the maximum load allowed per hour (see page 6).
Important handling to start your fire:
1
It is mandatory to half-open the door during 15 minutes to use the appliance properly
and to gain a sufficient temperature in the stove.
2
Close the door when the glass is warm. The combustion air inlet is adjusted with a
manual control. Adapt its position to insure appropriate air amount according to the
load of wood.
ATTENTION
-
Before reloading, open the door slowly to prevent smoke backdraft in the room;
-
To ensure optimal working, do not remove completely ash of the stove;
-
The stove is designed to operate with the door closed after lighting the fire. Reload when
only glowing embers remain;
-
We advise you to use fire starter cube which facilitate a quicker and cleaner wood
combustion.
Do not use liquid flammable products!
Combustion
Combustion air
Combustion air is adjusted with a pull opening more or less the combustion air valve. Adapt
its position according to the load of wood placed in the stove. The more wood in the stove,
the more air is needed for combustion.
Chimney
Smoke produced by wood combustion is evacuated by the chimney.
-
Good draught results from a huge difference in temperature between the inside of the
chimney and the outside of the house.