Jidé s.a. – Rue des Meuneries 11 – B-4650 HERVE (Belgique) – Tél. +32 87 31.75.12 – Fax +32 87 31.75.11 –
Modul-ART (EN) June 2018
9
INSTALLATION GUIDELINES
Preparation
When you receive the stove, it is important to check if there is no damage occurred during
transport.
Basis of the stove
The stove will be placed on a solid and flat surface, whose robustness will be sufficient to
bear the weight of the stove and of the chimney.
Radiated heat of the stove
Heat may be radiated through the glass and the convection air. Ensure any materials exposed
to this radiated heat are resistant to high temperatures.
Space from the fire:
Backward 150 mm
Sides 400 mm
Forward 1200 mm
Connection
To ensure an airtight connection adapted to the wished installation and to the good working
of your stove, contact your installer who will give you the helpful information.
The chimney section must, if possible, be the same as the stove's section. If chimney section
is much greater than the output of the appliance, we advise you to instal a pipe along the
length of the chimney and to insure the airtight of the connection. Be alert to the state of the
existing chimney and even more to the connection of the flexible to this existing chimney. A
bad connection can lead to damages. Use only stainless steel pipe appropriated to this use.
It is mandatory to put from the device at least 1 m hard or flexible pipe, in steel or in stainless
steel, to connect the smoke exit.
A chimney for a stove must have a normal draught, at its maximum power, the draught must
be placed between 12 and 20
Pa.