JH Industries Copperloy, Инструкция по установке и эксплуатации

Страница: 11 / 28

8
WARNING !
CAPACITY
JH INDUSTIRES INC.
The load capacity rating as specified on the
serial tag of your dock lift designates the gross
capacity, assuming uniformly distributed loads.
This capacity must never be exceeded, as
permanent damage may result. The relief valve has
been preset to raise the indicated capacity plus an
overload. In the case where special tops, gravity roll
sections, etc. are installed on the lift after leaving
our factor, deduct the weight of these from the load
rating (gross capacity) to obtain the net capacity.
The maximum rollover capacity in fully
lowered position is to be the maximum rated lifting
capacity. Applying loads exceeding the rated
capacity can result in excessive wear or damage to
the lift and injury to personnel.
For end and side loading, reduce the end
and side loading capacity by 2% for every inch
added to the standard minimum length or width.
i.e. : (4,000# 24”x48” = 4,000# gross capacity)
4,000# 24”x60” = 3,040# end load, 4,000# side load
4,000# 48”x72” = 2,080# end load, 2,080# side load
Never exceed dock lift capacity. Over loading
could result in damage to lift, property damage,
serious injury or death.
OWNER and USER RESPONSIBLITIES
Owners/users shall apply sound principles of safety,
training, inspection, maintenance, and expected
operating environment.
It shall be the responsibility of the owner/user to
advise the dealer or manufacturer where deflection
may be critical to the application.
Owners/users shall keep and maintain a copy of the
operating and maintenance manual(s) and ensure
its availability to operating and maintenance
personnel.
It shall be the responsibility of the users to inspect
and maintain the dock lift as required to ensure
proper operation. The frequency of inspection and
maintenance
shall be based upon the
manufacturer’s recommendations and be
compatible with operating conditions and the
severity of the operating environment. Dock lifts
that are not in proper operating condition shall be
immediately removed from service until repaired.
Maintenance and repairs shall be made by a
qualified person and the repairs shall be in
c o n f o r m a n c e
w i t h t h e m a n u f a c t u r e r ’ s
recommendations.
Before adjustments are started on a dock lift, the
following precautions shall be taken as
applicable:
•
Remove the load from the platform.
•
Lower platform to the full down position, if
possible or secure by maintenance device
and/or blocking as described by the
manufacturer to prevent unintended platform
movement.
•
Relieve system pressure from all circuits
before
loosening or removing any
components.
•
All controls in the “off” position and all
operating features secured from inadvertent
motion by brakes, blocks or other means.
•
Disconnect power and follow established
owner/user lockout/tagout policies.
•
Follow precautions and directions as
specified by the manufacturer.
When parts or components are replaced, they shall
be replaced with parts or components approved by
JH Industries, Inc.
The user shall ensure only qualified personnel
inspect and maintain the industrial scissors lift in
accordance with this section (Owner and User
Responsibilities) and with the manufacturer’s
recommendations as described in this manual.
An owner/user who directs or authorizes an
individual to operate a dock lift, shall ensure that the
individual has been:
•
Trained in accordance with the manufacturer’s
operating manual.
•
Made aware of the responsibilities of operators
as outlined in this manual.
•
Retrained, if necessary, based on the owners/
user’s observation and evaluation of the
operator.