13
6
Maintenance and Inspection
Before use
6.1
(1)
Check that the sensor surface is free of any foreign object.
(2)
Check that there is no loose or damaged connector or screw.
(3)
Span/zero calibration is recommended before use.
(4)
Make sure to remove the protection cap before use.
Maintenance after use
6.2
(1)
After use, clean well with fresh water. If something cannot be removed by water, gently remove it with a
soft cloth. Rubbing it hard can damage the oxygen detection film.
(2)
After water cleaning, remove the moisture either by an air blower or by wiping with a soft cloth.
(3)
Check if there is no scratch or damage on the sensor.
Storage
6.3
(1)
For storing, avoid places with high temperature, high humidity, or direct sunlight.
(2)
Place the sensor protection cap when storing in order to protect the sensor and prevent degradation.
(3)
Avoid places with temperature higher than 40 °C as it can cause output error or degradation of the
oxygen detection film.
Содержание RINKO FT
Страница 2: ......
Страница 36: ...34 Dimensions are in mm Figure 9 3 Cable type ARO FT Figure 9 4 MCBH type AROD FT...
Страница 39: ......
