JF 1000 AT, Руководство по эксплуатации и техническому обслуживанию

Страница: 76 / 92

32
Operation Technical Manual
C
B
T
A
T
J
B
R S
Observe that with the head, some spacers (A) are
supplied. These spacers are used for aligning the
sprocket (B) with the head’s sprocket (C).
1.
Put the sprocket (B) on the shaft, using three
spacers under the sprocket. Do not fix the
sprocket yet.
2.
Using a ruler, check if the sprockets are aligned.
If needed, remove or add spacers under the
sprocket (B), until achieve alignment.
3.
After achieving alignment, remove the sprocket
(B) from the shaft.Coloque la cubierta (J) en la
caja de transmisión de cambio de corte. Fije la
cubierta con los 2 tornillos (T).
4.
Put the cover (J) on the cutting change gearbox.
Fix the cover with the two bolts (T).
NOTE!
IMPORTANT!
The cover (J) is not the platform cover, but the
cover supplied with the head (this cover has a
hole for assembling the sprocket).
The sprockets must work perfectly aligned,
otherwise, the chain will be damaged.
ASSEMBLY OF THE SPROCKET ON THE
HARVESTER
RULER
NOTE!
S = hex bolt M8 X 30 (01 un)
R = flat washer Ø43 mm x Ø12 mm x 6,35 mm
(01 un)
The screws, nuts and washers are located in the
kit supplied with the head .