JF-Stoll FC 855, Инструкция по эксплуатации

Страница: 6 / 64

1. INTRODUCTION
1. INTRODUCTION
INTENDED USE
The precision chop forage harvester FC 855 is solely constructed and
manufactured for the usual work in agriculture, i.e.: Usual work in fields where
you want to cut/gather and chop green crops such as grass or whole crop, which can
be picked up from swaths, which are to be used for silage production intended for
coarse fodder for cattle.
The machine should only be connected to a tractor which corresponds with the
specifications of the product and is legal to use.
Any use beyond this is outside the intended use. JF-Fabriken A/S is not
responsible for any damage resulting from such use, the user bears that risk.
It is assumed that the work is performed under reasonable conditions, i.e. that the
fields are cultivated normally and to a reasonable extent kept clear of foreign matter
and the like.
Intended use also means that the instructions given by JF- Fabriken A/S in the
instruction manual and the spare parts book are observed and that thorough
agricultural knowledge and technically correct use is a matter of course.
The precision chop forage harvester FC 855 should only be used, maintained
and repaired by persons who, through relevant instructions and after reading
the instruction manual, are familiar with the machine and, in particular, are
informed of possible dangers.
In the following there are a number of general and special safety instructions which
must be observed altogether.
If changes are made on the machine and its construction without permission from JF-
Fabriken A/S, JF-Fabriken A/S cannot be held responsible for any damage resulting
from this.
PERFORMANCE
The FC 855 is capable of working alone or parallel with other machines.
FC 855 has a high capacity compared with other corresponding products as it uses
the “UPPER CUT” system. “UPPER CUT” gives a minimum loss of power when
cutting the material and thus ensures maximum utilisation of the accessible tractor
power.
Capacity, however, is difficult to define and compare as, for a forage harvester, it will
depend not just on which crop is being cut but also how the crop has been treated
before it is picked up or cut by the machine and finally which cutting length
adjustment the machine is working with.
PIGB-138X-02 FC 855 0410
- 6 -