22
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
Note:
If you have change the setting, you must let the system boot up until it goes to the
operating system, before this function will work
3-9 PnP/PCI Configuration Setup
This section describes configuring the PCI bus system. PCI, or
P
ersonal
C
omputer
I
nterconnect, is a system which allows I/O devices to operate at speeds nearing the speed the
CPU itself uses when communicating with its own special components. This section covers
some very technical items and it is strongly recommended that only experienced users should
make any changes to the default settings.
CMOS Setup Utility – Copyright(C) 1984-2004 Award Software
PnP/PCI Configurations
Item Help
x IRQ Resources Press Enter
PCI/VGA Palette Snoop Disabled
** PCI Express relative items**
Maximum Payload Size 128
Menu Level >
↑↓→←
Move Enter:/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
IRQ Resources
When resources are controlled manually, assign each system interrupt a type, depending on
the type of device using the interrupt.
PCI/VGA Palette Snoop
Leave this field at
Disabled.
The settings are Enabled, Disabled.
3-10 PC Health Status
This section shows the Status of you CPU, Fan, Warning for overall system status. This is
only available if there is Hardware Monitor onboard.
Phoenix – AwardBIOS CMOS Setup Utility
PC Health Status
Item Help
Shutdown Temperature Disabled
CPU Thermal Throttling Disabled
CPU Thermal-Throttling Temp 70
°
C
CPU Thermal-Throttling Duty 50.00%
CPU Thermal-Throttling Beep Enabled
Show PC Health in POST Enabled
Smart Fan Configurations Press Enter
Vcc 3V 3.39v
Vcore 0.94V
+1.05V 1.04V
+5V 5.04V
+12V 12.04V
5VSB 5.08V
VDIMM 1.17V
VSB3V 3.34V
CPU Temperature 53
°
C/127
°
F
System temperature 45
°
C/113
°
F
CPU FAN Speed 0RPM
Menu Level >
↑↓→←
Move Enter:/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
