20
IDE Primary Master/Slave UDMA
Ultra DMA100 implementation is possible only if your IDE hard drive supports it and the
operating environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus
master driver). If your hard drive and system software both support Ultra DMA 100 and Ultra
DMA/66, select Auto to enable BIOS support. The settings are: Auto, Disabled.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/write. If
your IDE hard drive supports block mode (most new drives do), select Enabled for automatic
detection of the optimal number of block read/writes per sector the drive can support. The
settings are: Enabled, Disabled.
3-7-2 Onboard Device Function
Phoenix – AwardBIOS CMOS Setup Utility
Onboard Device Function
Item Help
Onboard PCIE LAN Controller Enabled
Onboard PCIE LAN Boot ROM Disabled
High Definition Audio Enabled
USB HOST Controller Enabled
USB2.0 Function Enabled
USB Keyboard Support Disabled
USB Storage Legacy Support Enabled
Menu Level >>
↑↓→←
Move Enter:/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
USB Host Controller
Select
Enabled
if your system contains a Universal Serial Bus (USB) controller and you have
a USB peripherals. The settings are: Enabled, Disabled.
USB 2.0 Function
This setting allows you to enable/disable the onboard USB controller. Selecting [Enabled]
enables the system to support USB 2.0 spec, setting options: [Disabled],[Enabled].
USB Keyboard Support
Select
Enabled
if your system contains a Universal Serial Bus (USB) controller and you have
a USB keyboard. The settings are: Enabled, Disabled.
High Definition Audio
The selection for you to choose the embedded Audio function or 3
rd
party audio interface
installed. The settings are: Enabled and Disabled.
3-7-3 Onboard Super IO Function
Phoenix – AwardBIOS CMOS Setup Utility
Onboard Super IO Function
Item Help
Onboard Serial Port 1 3F8/IRQ4
Onboard Serial Port 2 2F8/IRQ3
UART2 Mold Select Normal
* IR Duplex Mold Half
Watch Dog Timer Select Disabled
*WatchDog Timer Value 255
*Watchdog Timer Unit Sec
Menu Level >>
↑↓→←
Move Enter:/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
