39
IRQ=3,4,5,7,10,11;]; [IO=3E0h; IRQ=3,4,5,7,10,11;]; [IO=2E0h;
IRQ=3,4,5,7,10,11;].
WatchDog Reset Timer
Use this item to enable or disable WDT reset function. When set as
[Enabled],
the
following sub-items shall appear:
WatchDog Reset Timer Value
User can select a value in the range of [4] to [255] seconds when ‘WatchDog
Reset Timer Unit’ set as [Sec]; or in the range of [4] to [255] minutes when
‘WatchDog Reset Timer Unit’ set as [Min].
WatchDog Reset Timer Unit
The optional settings: [Sec.]; [Min.].
WatchDog Wake-up Timer in ERP
This item supports WDT Wake-up while ERP function is set as
[Auto]
.
The optional settings: [Enabled]; [Disabled].
When set as
[Enabled]
, the following sub-items shall appear:
WatchDog Timer Value in ERP
User can set a value in the range of [10] to [4095] seconds, or 1~4095 minutes
WatchDog Timer Unit
The optional settings: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select ‘AT or ATX Mode’ on MB jumper at first (refer to
AT_COPEN jumper setting Pin 1&2 of AT Mode Select).
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
When set as [Enabled], system will detect if COPEN has been short or not (refer to
AT_COPEN
jumper setting for Case Open Detection; if
Pin 3&4
of jumper
AT_COPEN
are short, system will show Case Open Message during POST).
PC Health Status
Press [Enter] to view current hardware health status, set shutdown temperature, or
