45
USB transfer time-out
Use this item to set the time-out value for Control, Bulk, and Interrupt transfers.
The optional settings: [1 sec]; [5 sec]; [10 sec]; [20 sec].
Device reset time-out
Use this item to set USB mass storage device Start Unit command time-out.
The optional settings: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller.
The optional settings: [Auto]; [Manual].
‘Auto’
uses default value: for a root port it is 100 ms, for a hub port the delay is
taken from hub descriptor.
Select
[Manual]
you can set value for the following sub-item: ‘
Device power-up
delay in seconds’.
Device power-up delay in seconds
The delay range is from [1] to [40] seconds, in one second increments.
Network Stack Configuration
Press [Enter] to go to ‘
Network Stack
’ screen to make further settings.
Network Stack
Use this item to enable/disable WEFI Network stack
The optional settings: [Enabled]; [Disabled].
When set as
[Enabled]
, the following sub-items shall appear:
Ipv4 PXE Support
The optional settings: [Disabled]; [Enabled].
Use this item to enable Ipv4 PXE Boot Support. When set as [Disabled], Ipv4 PXE
boot option will not be created.
Ipv6 PXE Support
The optional settings: [Disabled]; [Enabled].
Use this item to enable Ipv6 PXE Boot Support. When set as [Disabled], Ipv6 PXE
boot option will not be created.
PXE boot wait time
