28
Recorder Mode
With this mode enable only text will be sent. This is to capture Terminal data.
The optional settings are: [Disabled]; [Enabled].
Resolution 100x31
Use this item to enable or disable extended terminal resolution.
The optional settings: [Disabled]; [Enabled].
Putty KeyPad
Use this item to select FunctionKey and KeyPad on Putty.
The optional settings are: [VT100]; [LINUX]; [XTERMR6]; [SCO]; [ESCN];
[VT400].
Serial Port for Out-of-Band Management / Windows Emergency
Management Services (EMS)
Console Redirection EMS
Use this item to enable or disable Console Redirection.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
Console Redirection Settings
Use this item to the settings specify how the host computer and the remote
computer (which the user is using) will exchange data. Both compatible settings.
Press [Enter] to make settings for the following sub-items:
Terminal Type EMS
The optional settings are: [VT100]; [VT100+]; [VT-UTF8]; [ANSI].
[VT-UTF8] is the preferred terminal type for out-of-band management. The next
best choice is VT100+ and then VT100. See above, in Console Redirection
Settings page, for more Help with Terminal Type/Emulation.
Bits per second EMS
Use this item to select serial port transmission speed. The speed must be
matched on the other side. Long or noisy lines may require lower speeds.
The optional settings are: [9600]; [19200]; [57600]; [115200].
Flow Control EMS
Flow Control can prevent data loss from buffer overflow. When sending data, if
the receiving buffers are full, a ‘stop’ signal can be sent to stop the data flow.
Once the buffers are empty, a ‘start’ signal can be sent to re-start the flow.
Hardware flow control uses two wires to send start/stop signals.
The optional settings: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff].
USB Configuration
Press [Enter] to make settings for the following sub-items:
USB Configuration
XHCI Hand-off
This is a workaround for OSes without XHCI hand-off support. The XHCI
ownership change should be claimed by XHCI driver.
The optional settings are: [Enabled]; [Disabled].
USB Mass Storage Driver Support
Use this item to Enable or Disable USB Mass Storage Driver Support.
The optional settings are: [Disabled]; [Enabled].
USB hardware delays and time-outs
USB Transfer Timer-out
