32
Use this item to selects serial port transmission speed. The speed must be
matched on the other side. Long or noisy lines may require lower speeds.
The optional settings are: [9600]; [19200]; [57600]; [115200].
Flow Control
Use this item to flow control can prevent data loss from buffer overflow. When
sending data, if the receiving buffers are full, a
‘stop’ Signal can be sent to stop
the data flow. Once the buffers are empty, a
‘start’ signal can be sent to re-start
the flow. Hardware flow control uses two wires to send start/stop signals.
The optional settings are: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff].
Data Bits
The default setting is: [8].
*This item may or may not show up, depending on different configuration.
Parity
The default setting is: [None].
*This item may or may not show up, depending on different configuration.
Stop Bits
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
Network Stack Configuration
Press [Enter] to go to ‘
Network Stack
’ screen to enable or disable UEFI Network
Stack.
Network Stack
The optional settings are: [Enabled]; [Disabled].
When set as [Enabled], the following sub-items shall appear:
Ipv4 PXE Support
The optional settings are: [Disabled]; [Enabled].
Use this item to enable Ipv4 PXE Boot Support. When set as [Disabled], Ipv4 boot
option will not be created.
Ipv4 HTTP Support
The optional settings are: [Disabled]; [Enabled].
Use this item to enable Ipv4 HTTP Boot Support. When set as [Disabled], Ipv4
