14
The connectors for PS/2 keyboard and PS/2 Mouse.
(4) USB Port connector: USB0/USB1
The connectors are 4-pin connector that connect USB devices to the system board.
(5) LAN Port connector: UL1/USBLAN
This connector is standard RJ45 connector for Network
The UL1 support 10M/100Mb/s data transfer rate (not for 754TURBO-G)
The USBLAN support 10M/100M/1G b/s data transfer rate (not for 754TURBO-P)
(6) Parallel Port Connector (25-pin female): PARALLEL
Parallel Port connector is a 25-pin D-Subminiature Receptacle connector. The On-
board Parallel Port can be disabled through the BIOS SETUP. Please refer to Chapter 3
“INTEGRATED PERIPHERALS SETUP” section for more detail information.
(7)
Audio Line-In, Lin-Out, MIC, Surrback, Surround, CEN/LEF Connector : J1
This Connector are 6 phone Jack for LINE-OUT, LINE-IN, MIC, Surrback, Surround,
CEN/LEF
Line-out : (GREEN)
Audio output to speaker
Line-in : (BLUE)
Audio input to sound chip
MIC : (PINK)
Microphone Connector
Surrback : (ORANGE)
Audio output to speaker-Rear speaker out
CEN/LEF : (BLACKNESS)
Audio output to speaker-Center/Subwoofer speaker out
Surround : (GRAY)
Audio output to speaker-Side speaker out
(8) Serial Port COM1/COM2 : COM1/COM2
COM1 is the 9-pin D-Subminiature male connector. The On-board serial port can be
disabled through BIOS SETUP. Please refer to Chapter 3 “INTEGRATED PERIPHERALS
SETUP” section for more detail information.
(9) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
PS/2
Mouse
PS/2
Keyboard
COM1
COM2
USB1
Giga LAN
USB
Surround
Line-IN
MIC-IN
Line-OUT
Surrback
CEN/LFE
10/100M
LAN
