13
10. Troubleshooting guide
Fiber becomes jammed in the pipe
1. Inform the people at the other end of the pipe that a
problem has been experienced and the operator is
going to shut down the system.
2. Shut off the pneumatic air supply with the air control
valve, allowing the air pressure to be depressurized from
the pipe and the pipe clamp air block.
3. Using the counter or the measurement on the fiber,
determine where the blockage might be located.
4. Notify supervisor about problem and determine a
solution
accordingly.
Wheels does not pull the fiber
1. Assist the reel by pushing the fiber of the reel.
The fiber run is hard to restart after
1. Put more air to the system. with the belt drive
having stopped
2. The wheel can be restarted after the air pressure has
increased and stabilized.
Wheel feed does not start
1. Battery is low, check battery meter in the display.
2. Overtemp may have occurred. The display shows
“OVERTEMP” and the motors needs to cool down under
75 degrees Celsius. Do not use compressed air or water to
cool down the machine, just let it wait until it cools down
by
itself.
