Jetter JetWeb JetMove 203-230, Руководство пользователя

Страница: 63 / 90

JetMove 203-230
Jetter AG 63
8 Status Monitoring
The amplifier LEDs indicate the operating status of the digital servo amplifier.
JetMove 203-230 - LEDs
LED Colour State Meaning
5V Green is lit Logic module voltage is OK
L1 Yellow is lit Axis is standing still (speed = 0)
L2 Yellow is lit A voltage of 24 V is applied to the input of
the positive limit switch (LIMIT+).
L3 Yellow is lit A voltage of 24 V is applied to the input of
the negative limit switch (LIMIT-).
Note!
The 7-segment display of the output stage indicates the operating and fault
conditions of the digital servo amplifier JetMove 203-230. The various display
modes are set by the Motion Setup. Mode 0 (default) is used for normal operation
and mode 1 for commissioning.
JetMove 203-230 - 7-Segment Display
Mode 0: Normal Operation
Display State Meaning
0 NOT READY TO BE
SWITCHED ON Initialisation of amplifier functions
1 INITIALIZATION
COMPLETE Initialization completed. Safe state. Is
achieved after initialising and after
acknowledging errors.
The drive controller can be switched
on.
2 READY TO BE SWITCHED
ON Drive controller has been disabled by
software command.
The drive controller can be switched
on.
3 SWITCHED ON DC link monitoring is activated.
4 OPERATION_ENABLED The drive controller has been
enabled.