© 2013 Jetta Corporation
.
All rights reserved. REV 06/2013
800-288-7771
6
owner’s manual
Verbiage Copy
maintenance
&
cleaning
Cleaning:
Cleaning should be done with a damp cloth and a window cleaner (i.e. Glass Plus, Windex, etc.).
1.
NEVER
WITH ANY SOLVENTS
. Do not use an abrasive or chemical based cleanser of any kind. The fittings should
be wiped off with a damp cloth only. Bubble Bath or bath oils are not recommended for whirlpool, air or
combination baths. See dealer for specific cleaners.
If you desire additional lustre on your bath surface, you may use a good automotive wax recommended
2.
for plastic surfaces. Do not wax the floor, for this may cause a slip hazard. Light scratches and abrasions
may be removed and the original gloss restored by using a light buffing compound. Use a damp cloth, rub
in small circles until scratches or abrasions are gone, then wipe with a dry cloth until the original gloss is
restored.
Repairs of any kind, if necessary, should be done by qualified acrylic experts.
3.
Proper installation and maintenance will ensure years of service and make you proud to own an
4.
Affinity bath by Jetta Corporation.
It is recommended that your whirlpool or air system be flushed twice per month. More frequent service may be
required depending on usage.
flushing Procedure:
Fill your bath with hot water.
1.
Add 2 tablespoons of low-foaming automatic dishwasher detergent (i.e. Cascade, Sunlight, etc.)
2.
Add 1/2 cup of household bleach to the water.
3.
Run the whirlpool for a minimum of fifteen minutes.
4.
Drain Bath
5.
Refill with cold water and operate the whirlpool for fifteen minutes.
6.
Drain Bath.
7.
NEVER operate a whirlpool bath without first filling the tub with water to 2” above
jets
Repair:
If any problems should develop, call your installer, dealer or the factory at (800) 288-7771.
