Jetmaster 18f, Инструкции по установке, эксплуатации и обслуживанию

Страница: 26 / 4884

26
Door Operation
To open the door, insert the operating control into the door latch on the right hand side of the door. Turn the
operating tool anti clockwise to open and clockwise to close.
Wood Burning
When burning wood then it should be burnt on the bottom board grate.
Allow the ash to build up to about 1” (25mm) deep in the base to ensure even and efficient burning.
Ash Removal. After several burns as the ash builds then it can be raked gently through the holes so as to fall in
the ash pan below. This can be emptied by sliding out. If ash builds at the sides and cannot be removed through
the holes then it is desirable to clean out a few shovels full of the surplus ash as required. (This will be more
frequent if burning heavily).
When removing the ash pan and replacing always ensure that it is fitted the correct way around. The ash pan
should be fitted with the handle facing to the front.
Lighting with Wood
When lighting the fire, the air control should be opened fully by sliding the operating lever to the fully open
position. The fire may be lit using proprietary firelighters with kindling wood. The door should be left slightly open
when lighting. This helps allow additional air into the fire and the glass to warm up thus avoiding soot forming on
the glass. Once the fire has established then slightly larger pieces may be added and the door closed. Do not
put too many logs on until the fire has a hold as this can smother the fire. At this point split logs or whole logs
may be added. The right technique comes with a little experience, and varies with the type of fuel being burnt.
See sections on Use of Air Supply Control and Fuels below.
DO NOT USE THE APPLIANCE AS AN OPEN FIRE ALWAYS USE IT WITH THE DOOR CLOSED.
Use of the Air Supply Control
The air control lever adjusts the primary air. The secondary air supply is pre-set to create simplicity for the user
to operate just one control. The primary and secondary air creates an air wash system drawing air across the
glass. This helps to keep the glass clean.
Air control lever being operated with the
end of the “door opening operating tool”
It reduces or increases the amount of air drawn into the fire to give the optimum burn and to carry away the
smoke. It also has an effect upon the burning rate of the fire. The degree of control exercised by the air control
lever is dependent on the draw of the chimney.