Jetmaster 18f, Инструкции по установке, эксплуатации и обслуживанию

Страница: 12 / 4884

External air supply pipe fitted
Fitting the Fire
Site Preparation for Fitting
Builders Opening
If installing the fire in an existing fireplace, first remove all loose material from the recess and measure the
opening and recess to ensure that the Jetmaster stove, when fitted, satisfies the clearance specified in Part J of
The Building Regulations. The recess must be large enough to provide a clearance around the sides and back
that confirms with the regulations. The optional extra heat shield may need to be fitted. Allow extra height if
connecting directly to the existing flue to make the connection.
Do not remove any structural lintels without first seeking expert advice. Often identification and location of the
lintel can be found by removing some surface plaster above the opening that is to be altered.
For details of stove sizes see installation data table.
The fire must be directly connected to the flue system. With an existing flue check that a sealed flue connection
can be achieved between the fire adaptor and the flue.
Inglenook Installations or freestanding
Flue liners or flue pipe used must be of the correct size for the fire and must be suitable for use with solid fuel
fires. Flue pipes of aluminium or asbestos may not be used, nor may flexible pipes of aluminium or single wall
stainless steel.
Appliance Preparation
Door Removal
Unlock the door with the handle provided.
Open the door fully and carefully support the door, at the same time pull down the spring loaded pin at the top
of the door and lift the door up and outwards away from the lower hinge attachments on the firebox. Set aside
in a safe place for refitting later.
12