Jeti Duplex DC16, Руководство пользователя

Страница: 72 / 109

computer radio control system
EN
4. 4.
2. Enable an Alarm
Using the „3D button“ , select „Enabled“ and press to enable the
alarm and display the alarm parameters.
3. Parameter Values
„Condition“ defines the condition which must be met in order to
trigger the alarm. The value „X“ will vary with the sensor being used.
4. File
This item allows you to select the audio file that is played when the
alarm occurs. Press
„F1“ to play the selected audio file. Press „F2“ to
stop playing the selected audio file.
5. Repeat
If the alarm condition occurrence is longer than the selected audio
file, you can use this item to repeat the audio file. If a check mark is
displayed then the audio file will repeat. If an
„x“ is displayed then
the audio file will play only once.
6. Set Throttle Idle
With this item activated, you model’s throttle will go to idle when the
alarm condition occurrs.
7. Activation Switch
If the switch is assigned, the alarm is enabled or disabled according
to the switch status.
9.4.3 Vario
Located in: „Menu->Timers/Sensors/Vario ”. There are two types of
acoustic signalling. The first one is controlled directly by the sensor's
alarm. This is mainly useful if a non-EX MVARIO is installed inside the
model. It is possible to assign a switch that enables or disables the
sound. The slider at the bottom shows the actual value of climb/sink
rate.
The second mode of the Vario is dedicated to EX sensors. The
acoustic signalling varies directly depending on the actual
numerical values sent by the sensor. It is also possible to assign a
switch that enables the acoustic signal.