EN
MAX BEC / SBEC
MAX BEC / SBEC
Notice:
1. Always follow the same procedure when switching on/off. To
switch-on, first connect the batteries and then use the
magnetic or RC switch to activate the unit. To switch-off, always
use the magnetic or RC switch to turn-off the unit before
disconnecting the batteries.
2. In order to ensure a proper function of the regulator always
take care of an sufficient amount of cooling air throughflow.
2.4.4 Switch - RC switch
MAX BEC 2D PLUS
supports on/off via RC Switch. It can be easily
used in JETI DC/DS transmitters.
1.
Disconnect the connector with a lock on the three-wire cable and
separate the magnetic switch.
2.
Connect
MAX BEC 2D Plus
with RC Switch (conrol output) using
three-wire cable.
3.
Bind the RC Switch with your transmitter and configure it in main
„menu/model/device explorer/RC switch”
.
12 EN
2.4.5
Connection of MAX BEC 2D Plus telemetry to the
Duplex receiver
Connect the three-wire cable (red JR connector) of the
MAX BEC 2D
Plus
to the
Ext. input
of the Duplex receiver. For Rx receivers,
please set the
Ext. input
as JETIBOX/Sensor. At newer REX receivers
the Ext. input will be set automatically.
Telemetry of the MAX BEC 2D Plus:
MAX BEC 2D Plus
sends the following values to the JETI DC/DS
transmitter via the DUPLEX system:
Acc. Input Volt
– Shows the actual voltage of the power-supply
batteries A and B.
Temperature
– Shows the temperature of the MAX BEC 2D Plus.
Output voltage
– Shows the actual voltage on the output
