Jet VBS-18MW, Инструкция по эксплуатации и каталог запасных частей

Страница: 12 / 40

12
Adjusting Clearance between Fence and Table
Referring to Figures 13 and 14:
Check the clearance between the table and the
fence. The fence should not rub against the table
surface but be slightly above it. This gap should be
the same at the front of the table as it is at the rear.
If the gap between fence and table is not
consistent, loosen either of the
hex nuts on the
hook (Figure 14) and rotate the sliding pad until the
fence/table gap is consistent across the full length
of the table. When this is achieved, tighten both
hex nuts.
Check the adjustment of the hook at the rear of the
fence. The hook should be positioned so that it
overlaps the rear rail by approximately 1/8”
(Figure 14). To adjust the hook, loosen the
upper
hex nut and slide the hook in or out as needed. Re-
tighten upper hex nut.
Resaw Guide
For resawing attach the post (A, Figure 15) to the
fence with the lock knob (B, Figure 15). There is a
slotted hole in the fence that will accommodate the
resaw kit. Position the post so that it is centered
with the front edge of the blade. The resaw guide
will give you a taller, single point contact surface
during resawing.
Miter Gauge
1. Place the miter gauge in the table slot.
2. With a square verify the miter gauge face is
square to the blade.
3. If the miter gauge is not square to the blade
loosen the lock knob (C, Figure 15) and adjust
to the proper setting. Tighten the lock knob.
4. If the pointer is not at 90 degrees, loosen the
screw (D, Figure 15) holding the pointer and
move the pointer to 90 degrees.
5. Re-tighten the screw.
Adjustments
Table Tilt
1. Disconnect machine from power source.
2. Loosen the lock knobs (G, Figure 16).
3. Tilt table up to 45 degrees to the right, or up to
10 degrees to the left.
4. Tighten the lock knobs.
Note : Table stop bolt (F, Figure 16) must be
removed to tilt table to the left.
Figure 13
Figure 14
Figure 15
Figure 16