Jet VBS-18MW, Инструкция по эксплуатации и каталог запасных частей

Страница: 10 / 40

10
Chip Tray
Referring to Figure 8:
Insert two 1/4” x 1/4” pan head screws through the
holes in the rear rail and into the table edge,
leaving the screw heads protruding slightly. Mount
the chip tray onto the screws as shown.
Dust Collection
If cutting wood on the band saw, attach the hose of
a proper dust collection system to the 4” port at the
rear of the band saw. NOTE: Dryer vent hose is not
acceptable for this purpose.
If using the bandsaw for metal
working, DO NOT connect a dust collection
system designed for wood dust. Hot metal
shavings can pose a fire risk.
Fence Assembly and Adjustment
Assembling the Fence to Fence Body
Referring to Figure 9:
1. Attach the fence (A) to the fence body (B) with
four 5/16” x 3/4” socket head cap screws (C),
four 5/16” lock washers (D), and four 5/16” flat
washers (E). Hand-tighten only at this time.
Assembling the Rear Hook
Referring to Figure 10:
2. Thread a 1/4"-20 hex nut (B) onto the pad’s
threaded stud (A) and insert through the
fence (C) so the threaded stud is now inside
the fence.
3. Place the rear hook (D) on the threaded stud.
Finish the assembly by placing a 1/4" flat
washer (E), 1/4" lock washer (F) and 1/4" hex
nut (G) on the threaded stud, and finger
tighten.
Note: Adjust for a gap of approximately 1/8"
between the pad (A) and hook (D) and as
shown in the inset.
4. Tighten the assembly using two 10mm
wrenches.
Figure 8
Figure 9
Figure 10