Jet JWS-25CS, Руководство пользователя

Страница: 8 / 24

8
Electrical Connections
WARNING
All electrical connections must be done by a
qualified electrician!
Failure to comply may cause serious injury
and/or damage to property!
The JWS-25CS is rated at 230V single phase
only. The machine must be properly grounded.
Electrical Controls
The shaper is equipped with a push-button
control system and reversing switch. The green
start and red stop push buttons are mounted in a
control enclosure on the front of the machine.
To reverse the rotation of the spindle, shut off
the motor, allow motor to come to a complete
stop, and rotate the reversing switch.
Spindle Installation and Removal
WARNING
All adjustments to the machine must be
made with the power off and unplugged
from the power source!
Failure to comply may result in serious
injury!
To install:
1.
The shaper comes with a 1/2" and 3/4"
spindle assembly.
2. Raise the spindle fully by turning handwheel
clockwise.
3. Clean the spindle and spindle housing.
4. Place the spindle into the spindle housing
and line up the cut out portion of the spindle
with the raised section of the spindle
housing.
5. Completely thread the drawbar (Fig. 4) into
the spindle through the bottom of the main
spindle housing.
6. Tighten the drawbar nut (B, Fig. 4) while
holding the spindle nut, or spindle flat (A,
Fig. 3). Make sure the left hand thread
safety lock nut is installed above the spindle
nut, and tightened.
To remove:
1.
Raise the spindle fully.
2. Remove two knobs that hold the guard
assembly to the dust chute. Place an
adjustable wrench on the spindle nut, or
spindle flat (A, Fig. 3).
3. Loosen the draw bar nut (B, Fig. 4) with a
14mm wrench, and tap upward lightly with a
block of wood to break the spindle loose.
4. Finish removing the draw bar and lift out the
spindle from the top.