8
2. Thread adjustable feet (A, Fig. 1) into stand leg
(B, Fig. 1). There is a flat spot on the shaft near
the foot that will accommodate a wrench.
Thread a hex nut (C, Fig. 1) onto shaft and
leave loose for now.
3. Mount the leg to lathe bed with four 5/16” flat
washers and four 5/16”-18 x 1-1/2” hex socket
cap screws (D, Fig. 1).
4. Repeat for the other leg.
5. Adjust the feet so that the lathe rests evenly on
the floor, and tighten the nuts.
6. Reinstall headstock, tailstock and tool rest.
Tool Rest
Secure tool rest (A, Fig. 2) to tool rest body
(B, Fig. 2) by tightening handle (C, Fig. 2).
Note:
For some turning applications, you may need
to assemble the tool rest extension between the
tool rest body and tool rest.
Stand Shelf
You can make an extra shelf that rests between the
legs if you wish, see Figure 3. It will be useful for
storing lathe accessories, or adding sand bags for
some extra weight. The two 2x4’s should be 55-
3/4” long. The plywood should be ripped into two
equal pieces 27-13/16”L x 17”W so that it can be
assembled between the legs. Use screws to attach
the plywood to the 2x4 supports.
Figure 2
Figure 3
Содержание JWL-1442VSK
Страница 26: ...25 Headstock Assembly...
Страница 29: ...28 Wiring Diagram...
Страница 31: ...30 Notes...
Страница 32: ...31 Notes...