5
23. Test each set-up by revolving the work by hand to insure it clears the tool rest and bed. Check the
setup at the lowest speed before increasing it to the operating speed.
24. Use the correct cutting tool for the operation to be performed and keep all tools sharp.
25. Use low speeds for roughing and for long or large diameter work. If vibration occurs, stop the
machine and correct the cause. See the speed recommendation chart below:
Diameter of Work
Roughing RPM
General Cutting RPM
Finishing RPM
Under 2"
1500
3000
3000
2 to 4"
600
1500
2300
4 to 6"
450
1100
1500
6 to 8"
450
600
1100
8 to 10"
450
600
850
10 to 12"
450
600
850
12 to 14"
450
450
600
Speed Recommendations
26. When sanding, remove the tool rest from the machine, apply light pressure and use a slow speed to
avoid heat build up.
27. When turning large diameter pieces, such as bowls, always operate the lathe at low speeds. See the
speed recommendation chart.
28. Do not attempt to engage the spindle lock pin until the spindle has stopped. If leaving the machine
area, turn it off and wait until the spindle stops before departing.
29. Make no adjustments except speed changes with the spindle rotating and always disconnect the
machine from the power source when performing maintenance to avoid accidental starting or
electrical shock.
30. Provide for adequate space surrounding work area and non-glare, overhead lighting.
31. When stopping the lathe, never grab the part or faceplate to slow it down. Let the work coast to a
stop.
32. Use only JET factory authorized replacement parts and accessories; otherwise, the warranty and
guarantee are null and void.
33. Do not use this JET wood lathe for other than its intended purpose. If used for other purposes, Walter
Meier (Manufacturing) Inc., disclaims any real or implied warranty and holds itself harmless from any
injury that may result from that use.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or
possible machine damage.
This means that if precautions are not heeded, it may result in serious injury or possibly
even death.
Содержание JWL-1442VSK
Страница 26: ...25 Headstock Assembly...
Страница 29: ...28 Wiring Diagram...
Страница 31: ...30 Notes...
Страница 32: ...31 Notes...