12
8.3.1
Belt Tension Adjustment
1. Unplug sander from power source.
2. Adjust take-up screw nuts (Figure 8-2) with
5mm hex wrench. Do this on both sides of
conveyor to obtain approximately equal tension
on both sides of sanding belt when taut.
NOTE: Insufficient belt tension will cause
slippage of conveyor belt on drive roller during
sanding operation. The conveyor belt is too
loose if it can be stopped by hand pressure
applied directly to top of moving conveyor belt.
Excessive belt tension can result in bent rollers,
bent brackets, and/or premature wearing of
bushings or conveyor belt.
Figure 8-2: Belt Tension Adjustment
8.3.2
Tracking Adjustment
A belt tracks correctly when it moves centrally on the
conveyor rollers without drifting to either side.
Tracking adjustments are made while conveyor belt
is running.
1. Unplug sander from power source.
2. Make sure proper belt tension has been
achieved (see
sect. 8.3.1
).
3. Turn on conveyor and set to maximum speed.
Watch for tendency of conveyor belt to drift to
one side of conveyor. If it drifts, tighten or
loosen take-up screw.
Note:
Adjust take-up screw only 1/4 turn at a
time. Allow time for belt to react to adjustments
before proceeding further.
Try to avoid over adjustments, as this may
affect belt tension. If tension is affected, if may
become necessary to use both take-up screws
to accomplish tensioning and tracking.
8.3.3
Trackers
The sander comes equipped with “Trackers”,
ceramic guides that reduce the amount of
adjustments needed to keep conveyor belt tracked
(centered) on conveyor table. These guides have a
magnetic backing to keep them in place. If a Tracker
wears through, it can be reversed by turning it over.
See
sect. 11.0 Tracker Kit
for more information
about re-setting trackers.
8.4
Inspecting Drum Alignment
The sanding drum must be parallel to conveyor table
for proper machine operation. The sanding drum
comes pre-aligned from the manufacturer. If a
problem with drum alignment should occur, follow
the instructions below.
First, inspect the alignment with a gauge of some
kind. The following procedure uses a steel straight-
edge as a gauge.
1. Unplug sander from power source.
2. Open dust cover and remove abrasive strip
from drum.
3. Insert gauge between drum and conveyor table
at outboard side of drum (A, Figure 8-3).
Figure 8-3: Drum Alignment
4. With dust cover open, lower sanding drum while
slowly rotating drum by hand, until drum lightly
contacts gauge. NOTE: Make sure drum
contacts gauge, not just the tension rollers.
5. Remove gauge and place under drum at
inboard side.
6. If drum does not contact gauge equally on both
ends of drum, alignment is needed.
To align conveyor table with drum:
7. Loosen both table locks (B, Figure 8-3)
Loosen both table locks
before adjusting drum alignment.
8. Turn knob (C) to raise or lower outboard end of
table. Follow directional marks on label (
+
raises,
-
lowers).
9. Retighten table locks (B).
