17
Figure 10-3: Drum Removal
Figure 10-4: Drum Removal
Figure 10-5: Drum Removal
Figure 10-6: Drum Removal
10.3
Conveyor Belt Replacement
5. Disconnect sander from power.
6. Raise drum to highest position.
7. Turn take-up screws (Figure 8-2) on both sides
of conveyor to relieve belt tension and slide the
driven roller fully inward.
8. Remove two (2) screws that attach conveyor
table to base.
9. Remove two (2) screws that attach conveyor
table to drum alignment bracket (E, Figure 10-
7).
10. Loosen two locks (F, Figure 10-7).
11. Lift conveyor table and remove it from machine.
Avoid tearing the belt on any edges underneath
the conveyor table.
Do not allow the Trackers to
drop, as they may break.
12. Set conveyor on motor side and slide conveyor
belt off end of conveyor table.
13. Install new belt along with trackers (see
sect.
11.0
), and re-install conveyor table. Tension
and track the new belt.
Figure 10-7
Note:
If conveyor belt continually tracks to one side
of the machine, reversing the belt on the conveyor
table may remedy the problem. To make sure the
conveyor table is not twisted, place a level on the
conveyor table. Level the machine if needed. If there
is still a problem, proceed with the steps below:
