Jet JTM-949EVS4, Инструкция по эксплуатации и каталог запасных частей

Страница: 6 / 48

6
28. Clamp workpiece or brace against column to
prevent rotation. For safety and use of both
hands, use clamps or a vise to hold work.
29. Use recommended speed for cutter/drill
accessory and workpiece material.
30. Direction of feed – feed work into a blade or
cutter against the direction of rotation of the
blade or cutter only.
31. Installation work and electrical wiring must be
done by a qualified electrician in accordance
with all applicable codes and standards.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or possible
machine damage.
This means that if precautions are not heeded, it may result in serious, or even fatal, injury.
4.0 About this manual
This manual is provided by JET, covering the safe operation and maintenance procedures for JET Model JTM-
949EVS series and JTM-1050EVS series Turret Mills. This manual contains instructions on installation, safety
precautions, general operating procedures, maintenance instructions and parts breakdown. Your machine has
been designed and constructed to provide consistent, long-term operation if used in accordance with the
instructions as set forth in this document.
If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our
web site: www.jettools.com.
Retain this manual for future reference. If the machine transfers ownership, the manual should accompany it.
Read and understand the entire contents of this manual before attempting assembly or
operation! Failure to comply may cause serious injury!
Register your product using the mail-in card provided, or register online:
http://www.jettools.com/us/en/service-and-support/warranty/registration/
WARNING: This product can expose you to
chemicals including lead and cadmium which
are known to the State of California to cause
cancer and birth defects or other reproductive
harm, and phthalates which are known to the
State of California to cause birth defects or other
reproductive harm. For more information go to
http://www.p65warnings.ca.gov.
WARNING: Some dust, fumes and gases
created by power sanding, sawing, grinding,
drilling, welding and other construction activities
contain chemicals known to the State of
California to cause cancer and birth defects or
other reproductive harm. Some examples of
these chemicals are:

lead from lead based paint

crystalline silica from bricks, cement and
other masonry products

arsenic and chromium from chemically
treated lumber
Your risk of exposure varies, depending on how
often you do this type of work. To reduce your
exposure to these chemicals, work in a well-
ventilated area and work with approved safety
equipment, such as dust masks that are
specifically designed to filter out microscopic
particles. For more information go to
http://www.p65warnings.ca.gov/ and http://www.
p65warnings.ca.gov/wood.