Jet JTAS-10DX, Инструкция по эксплуатации и каталог запасных частей

Страница: 15 / 28

15
Blade Alignment

Tools: 8mm hex wrench, combination square,
marker
Blade alignment with the table is adjusted at the
factory. After a period of use, or, after moving the
saw to another location, the blade may no longer
be aligned with the table.
To check and align the blade (refer to Figure 16):
1. Disconnect the saw from the power source.
2. Raise the blade guard up a way from the blade.
3. Choose a tooth on the far side of the blade
(towards the rear) and position the tooth
slightly above the table insert. Mark the tooth
with a marker. Measure the distance from the
side of the blade to the right T-slot edge using
a combination square. Make sure to measure
between the teeth not on the tooth (Figure 16).
4. Rotate the blade toward the front so that the
marked tooth is just above the insert. Measure
the distance from the side of the blade to the
right T-slot edge. The two measurements
should be the same.
5. If they are not the same, loosen four hex
socket cap screws (A, Fig. 17) that hold the
table to the base. Two are shown in Figure 17.
6. Make the needed adjustments and tighten the
four hex socket cap screws firmly.
7. Check the alignment once again after
tightening hardware.
Adjusting 45

and 90

Positive Stops
The stops have been adjusted at the factory. After
a period of use, or, after moving the saw to another
location, the stops may no longer be set properly.
To check and adjust the stops:

Tools: 12mm wrench, combination square
1. Disconnect saw from power source.
2. Raise the saw blade to its maximum height
using the handwheel.
3. Set the blade at 90 degrees to the table by
turning the blade tilting handwheel clockwise
as far as it will go.
4. Place a combination square on the table
against the blade and check to see that the
blade is at a 90

angle to the table, Figure 18.
Make sure square is not touching a blade
tooth.
Figure 16
Figure 17
Figure 18