Jet JTAS-10DX, Инструкция по эксплуатации и каталог запасных частей

Страница: 10 / 28

10
Extension Wing
Referring to Figures 4 and 5:

Hardware: (6) 7/16”x1-1/2” Hex Cap Bolts, (6) 7/16”
Lock Washers, (6) 7/16” Flat Washers & (2)
Extension Wings

Tools: 17mm Wrench, Straight Edge
1. Attach the left extension wing (A) to the
table (B) with three each hex cap screws (E),
lock washers (F) and flat washers (G). Snug so
the extension wing can still be manually
adjusted but do not tighten.
2. Adjust the extension wing horizontally so the
front edge is flush with the front edge of the
saw table (C). Then, using the straightedge as
reference, adjust vertically so the tops of the
extension wing and saw table are flush.
3. Tighten the three extension wing mounting
screws.
4. Remove the mounting hardware (Fig. 5) from
the table on the right side; then attach the right
extension wing in the same manner.
Blade Installation/Replacement
Use care when working with or
around sharp saw blade to prevent injury!
To install or replace a blade (refer to Figure 6):

Tools: 27mm Wrench
1. Disconnect machine from power source.
2. Raise the blade height all the way up and set
the blade tilt to 0º (refer to Handwheel
Adjustments on page 14).
3. Remove the table insert.
4. Rotate the arbor to line up the slot (C) with the
arbor lock (D).
5. Press the arbor lock (D) in the direction shown
by the arrow to engage it into the slot (C) in the
arbor . At the same time remove the arbor
nut (A), loosening with a 27mm wrench if
necessary.
6. Remove the collar (B).
7. Install the blade, making sure the cutting teeth
at the top of the blade point toward the front of
the saw. If unsure, refer to Figure 8 for the
proper blade orientation.
8. Replace the collar (B) and arbor nut (A).
9. Engage the arbor lock (D) and tighten the nut
(A) with a 27mm wrench.
10. Lower the blade below the table.
Figure 4
Figure 5
Figure 6