Jet JPJ-12B, Инструкция по эксплуатации и каталог запасных частей

Страница: 9 / 48

9
9.3 Control Switch
Refer to Figure 4:
Press the green switch to start. Press the red
switch to stop.
To prevent unauthorized or accidental starting of
the machine, remove the safety key from the
green switch and store in a safe place. The key
must be reinserted to start the machine.
Figure 4
9.4 Planer Controls and Adjustments
Refer to Figure 5:
Table Height Adjustment
To set the planer table height, rotate the height
adjustment handwheel (E) counterclockwise to
raise the planer table (C), clockwise to lower.
Each revolution of the handwheel (E) results in a
5/32" up or down movement of the table (C). A
scale on the handwheel column indicates the
amount of handwheel rotation. A
pointer (B)
indicates the table position relative to the
cutterhead on the
scale (A) located on the side of
the cabinet.
Power Feed
The gearbox has two feed speeds. These are set
by pulling out or pushing in the
shift lever (D).
Always change feed speed while the machine
is running.
A diagram showing lever positions
and associated feed speeds can be found above
the gearbox cover. It is also shown in Figure 6.
Planer must be running when
changing the feed rate. Do not attempt to
change the feed speed while stock is passing
through the machine. Failure to comply may
damage the gearbox.
Figure 5
Figure 6
9.5 Jointer Controls and
Adjustments
Outfeed Table Height Adjustment
Refer to Figure 7:
The outfeed table lock handle (C) and outfeed
table adjustment handle (B) control the height
adjustment of the outfeed table (A).The outfeed
table is initially adjusted at the factory and should
not be repositioned except during certain
adjustments. These are described in
sect. 10.2,
Table and Knife Adjustments .
Infeed Table Height Adjustment
Refer to Figure 7:
The infeed table lock handle (D) and infeed table
adjustment handle (E) control the height
adjustment of the infeed table (F).
To adjust:
1. Loosen the infeed table lock handle (D).
2. Raise infeed table adjustment handle (E) to
raise the infeed table (F) for a shallow depth
of cut. Lower the handle for a deeper cut.
3. Tighten the infeed table lock handle (D).
The infeed table adjustment handle in the fully
lowered position results in a depth of cut of 1/8".
Note: A depth of cut 1/16" or less is recom-
mended.