13
10.0
Troubleshooting JOSS‐S Spindle Sander
Symptom
Possible Cause
Correction
Sander will not start.
Sander unplugged from wall or motor.
Check all plug connections.
Fuse blown, or circuit breaker tripped in
service panel.
Replace fuse, or reset circuit breaker.
Cord damaged.
Replace cord.
Starting capacitor bad.
Replace starting capacitor.
Sanding drum does not
come up to speed.
Extension cord too light or too long.
Replace with adequate size and length cord.
Low current.
Contact a qualified electrician.
Machine vibrates
excessively.
Stand or base on uneven surface.
Adjust stand or base so that it rests evenly on
the floor.
Bearings worn.
Replace bearings.
Sanded edge not square.
Table not square to sanding drum.
Use a square to adjust table to sanding drum.
Sanding marks on wood.
Wrong grit sanding sleeve.
Use coarser grit for stock removal and fine grit
for finish sanding.
Feed pressure too great.
Do not force workpiece against spindle or
drum.
Table 3
11.0
Available accessories
Refer to the JET‐Pricelist for various grit sanding sleeves.
12.0
Environmental protection
Protect the environment.
Your appliance contains valuable materials which can be recovered or recycled. Please leave it at a specialized institution.
This symbol indicates separate collection for electrical and electronic equipment required under the WEEE Directive
(Directive 2012/19/EC) and is effective only within the European Union.
