Jet JMS-10X, Инструкция по эксплуатации и каталог запасных частей

Страница: 10 / 36

10
Read and understand the entire
contents of this manual before attempting
assembly or operation. Failure to comply may
cause serious injury.
6.0 Setup and assembly
6.1 Unpacking
Inspect contents for shipping damage or missing
parts. If either is discovered, report it to your
distributor.
Do not discard carton or packing material until saw
is assembled and running satisfactorily.
6.2 Shipping contents
1 Miter saw
1 Dust bag
1 Dust port adaptor
1 Hold-down clamp assembly
3 Hex wrenches, 2.5/3/6 mm
(6mm wrench is preinstalled in rear handle)
6.3 Tools required for assembly
Hex wrenches – 2.5mm, 6mm
(Additional tools may be needed for adjustment
procedures and securing the miter saw to a
workbench.)
6.4 Transporting the saw
Observe the following safety measures to avoid
injury from unexpected saw movement:

Disconnect power cord and wrap it around the
storage clips.

Bring cutting head to forward position and
down, and lock it in lower position.

Lock slide carriage in place.

Always use the carrying handles when lifting or
moving to avoid damage to machine.

Bend at the knees, not from the back.
6.5 Mounting saw to bench
For stationary use:
Select a location for the saw, such as the top of a
workbench, that provides sufficient room for
handling workpieces. Secure the saw to the bench.
Mounting hardware is not included and must be
purchased separately.
For portable use:
Place saw on a 3/4-in. thick piece of plywood and
bolt the base securely to the plywood using the
mounting holes on base. Mounting hardware is not
included and must be purchased separately.
Use C-clamps to clamp this mounting board to a
stable work surface at the worksite.
6.6 Releasing slide carriage
Loosen slide locking knob (A, Figure 8-1).
When transporting or storing
miter saw, the slide carriage should always be
locked in position.
6.7 Releasing cutting head
When not in use, lock cutting
head in down position. Failure to comply can
cause serious injury or equipment damage.
1. Push down on operating handle.
2. Pull out on head release pin (B, Figure 6-1).
3. Raise cutting head to UP position.
Note: When not in use, lock cutting head in down
position:
4. Pull out on head release pin (B) and bring
cutting head down.
5. Push in head release pin (B) to lock.
Figure 6-1
6.8 Dust extraction
6.8.1 Dust bag
Push dust bag onto exhaust port (Figure 6-1).
To empty dust bag, remove it from exhaust port,
slide off plastic clip (C
1
, Figure 6-1) and empty
sawdust through bag opening. Reinstall clip before
using dust bag.
Note: Inspect and empty bag frequently; do not wait
for it to become full.