Jet JEB-1, Инструкция по эксплуатации и каталог запасных частей

Страница: 13 / 20

13
Maintenance
Before doing maintenance
on the Edge Bander, unplug it from the
power source, unless specified otherwise.
Prolonged use of the Edge Bander may cause
accumulation of hot melt adhesive on the
guides, which can block free movement of the
edge banding material. To remove this
adhesive, plug in the tool and turn it on, with the
heat gun at a medium setting. Keep hands
away from hot air gun. As the heat gun softens
the hot melt adhesive, peel the adhesive from
the guides with a putty knife. Be careful not to
scratch the guides; they must remain smooth for
best results.
If the pinch roller needs cleaning, wipe it with
soap and water. Do not use solvents on the
pinch roller.
If the power cord is worn, cut, or damaged in
any way, have it replaced immediately.
Main Table Replacement
The laminated front table may eventually
become scuffed with use. It can be replaced
with any smooth faced stock. Remove the old
table by unscrewing and removing the two
socket head flat screws, shown in Figure 16,
with a 5/32” (or 4mm) hex wrench (not
provided). Use the old table as a pattern for
cutting the new one.
A plastic laminate face may be glued to the new
table. This will increase its durability and reduce
friction between the table and the workpiece. Be
sure the new table is the same thickness as the
original. Make an allowance for the plastic
laminate if you plan to laminate your new work
table.
Figure 16