Jet JEB-1, Инструкция по эксплуатации и каталог запасных частей

Страница: 9 / 20

9
Adjustments
Upper and Lower Guides
The upper and lower guides can be adjusted by
loosening the socket head cap screws with a
5mm hex wrench (provided). See Figure 4. After
adjustment, re-tighten the screws.
The lower guides should be set slightly below
the work table, after which no further
adjustments will be necessary for the lower
guides.
Adjust the upper guides to suit the width of your
banding material. NOTE: The banding material
must move freely through the guides.
Infeed and Outfeed Fences
The infeed and outfeed fences are used to
support the edge of the workpiece. Both fences
should be positioned in relation to the pinch
roller to allow for the thickness of the edge
banding material being used. Normally, the
fences will be recessed about 1/32” to 3/64”
from the crown of the pinch roller, as shown in
Figure 5. This setting has already been made
before the Edge Bander was shipped; however
you may wish to double-check it. It should also
be checked occasionally as the Edge Bander
receives use.
If a fence requires adjustment, loosen the two
socket head cap screws (Figure 5) and shift the
fence forward or backward as needed.
NOTE: To adjust the infeed fence, you must first
remove the hot air gun from the table as follows:
The hot air gun should be
disconnected from power. If the hot air gun
has just been used in an edge banding
operation, allow it to cool sufficiently before
attempting to remove it.
1. On the underside of the Edge Bander, use a
Phillips screwdriver to remove the two
screws which secure the hot air gun (Figure
6).
2. Carefully remove the hot air gun from the
table. The socket head cap screws on the
infeed fence will now be accessible; adjust
the infeed fence as needed.
3. When finished, re-install the hot air gun. Re-
install and tighten the two screws (Figure 6).
Figure 4
Figure 5
Figure 6