12
Support Frame
Mounting legs to motor & housing assembly
Referring to Figure 3:
1. Insert the three assembled legs (A) into the
channel brackets (B) on the side of the motor,
making sure that the tabs (C) of the connection
brackets point toward the center.
2. Line up the mounting holes of the legs (D) with
the channel brackets (E) and secure with
M8x12 hex cap screws (four per leg; 12 screws
total).
3. Tighten with a 12mm wrench or socket.
Support Plate
Referring to Figure 4:
1. While the dust collection unit is still upside
down, attach the support plate (A) to two
connection brackets (B) on the outside of the
frame as shown, placing making sure that the
tab (C) is pointing down.
2. Insert four M8x12 hex cap screws (D) through
the mounting holes on the support plate side
and secure with M8 hex nuts from the
connection bracket side. Tighten with a 12mm
and 13mm wrench.
3. Attach the remaining two support brackets in
the same manner.
At this time turn the dust collection unit right side
up.
This machine is heavy. Follow
the procedure below in order to prevent
personal injury and/or damage to the machine.
While two people lift and right the unit, a third
person is needed to prevent the system from
sliding forward by holding the feet in place.
Switch, Inlet Tube and Adapter
Referring to Figure 5:
Switch
1. Loosen any two adjacent hex nut and screw
assemblies that secure the funnel to the
separator and remove the hex nuts (B).
2. Attach
the
switch (A) to the dust collector by
resting the tab (C) against the underside of the
funnel lip such that the protruding screws (D)
pass through the mounting holes in the tab (C).
3. Secure with the hex nuts (B) that were
removed in step 1.
Figure 3
Figure 4
Figure 5
Inlet Tube
4. Secure the inlet tube (E) to the rectangular
opening (F) on the separator with six M8x20
hex cap screws (G) and six M8 hex nuts (H).
Adapter
5. Slide the adapter (J) onto the inlet tube (E).
6. Line up the mounting holes and secure with an
M5x12 pan head screw (K).
Содержание JC-3BF
