Jet JBM-5, Инструкция по эксплуатации и каталог запасных частей

Страница: 6 / 11

4
Assembly
,
WARNING
Never connect the machine to the power
source until assembly is completed.
Failure to comply may result in
serious injury!
1. Screw the handle (A, Fig. 2) into the pinion shaft (B,
Fig. 2).
2. Tighten the handle. The handle has a notch (C, Fig.
2) to accommodate a wrench.
3. Use the handle to raise the machine head to the up
position. The handle is spring loaded and can be
repositioned by pulling the handle away from the
machine, and turned to the desired angle.
4. With the head in the up position press the hydraulic
cylinder onto the two fittings. The upper fitting (D,
Fig.2) is located on the head. The lower fitting (E,
Fig.2) is on the column.
5. Attach the table to the base using two screws (A,
Fig.3).
6. Insert bar of fence assembly (B, Fig.3) through the
hole in the column. Use the fence-locking handle
(C, Fig.3) to adjust fence assembly.
7. Attach the hold down (D, Fig.3) to the
vertical post using locking handle (E,
Fig.3).
Installing
,
WARNING
Make sure the Mortising Machine
Is attached to a firm, and stable
support surface
This machine must be fastened to a supporting
surface to prevent it from tipping during
operation. Four holes (A, Fig.4) in the base
are supplied for this purpose.