JET
7
Setup and Assembly
Any missing parts or damage should be reported
immediately to your JET
®
distributor. Do not use a
damaged tool. Read this instruction manual
thoroughly for operation, maintenance and safety
instructions.
Box contents:
1 Impact
wrench
1 Side
handle
2
Socket head cap screws, M8x20
2 Washers,
8mm
1
Hex key, 6mm
1
Operation and parts manual
1 Warranty
card
Install side handle with screws and washers,
using provided hex key.
Operation
The impact wrench must be
properly lubricated before operation. See
“Lubrication” section.
Figure 1
1.
Remove protective cap from air inlet (Figure
1). If an in-line oiler is not being used, add 4
or 5 drops of air tool oil (not included) into the
air inlet.
2. Blow out air line to remove any dirt or
moisture, then connect air supply hose to
tool. Set air pressure to 90 psi.
IMPORTANT:
Connecting a quick-change
coupling directly to the tool is not
recommended, as vibration may cause the
connection to fail. Instead, add a leader hose
and install any quick-change couplings
farther down the line.
3.
Push drive socket (not included) onto anvil
until it clicks into position. (JAT-201 and JAT-
202 also contain a pin hole for further
securing of socket.)
4. Rotate regulator dial to preferred setting.
Regulator settings are for reference only and
do not indicate specific power settings.
Rotate right for forward direction (3 speeds).
Rotate left for reverse (3 speeds).
Make sure nut or bolt can
withstand rated torque of impact wrench.
To loosen nut or bolt:
1.
Select reverse rotation.
2.
Place socket over nut, hold D-handle grip
firmly, and grip side handle firmly with other
hand. Gently squeeze trigger.
Important:
If tool cannot loosen nut, DO
NOT raise air pressure above 90 psi. If tool’s
air regulator is in low setting, raise setting
and retry.
If tool’s regulator is already at
maximum, do not continue attempts to
loosen nut with this impact wrench.
Use
other methods or tools to loosen nut.
3.
Release trigger to stop impact wrench.
To tighten nut or bolt:
1.
Install nut as far as possible by hand.
2.
Select forward rotation.
3.
Place socket over nut, hold D-handle grip
firmly, and grip side handle firmly with other
hand. Gently squeeze trigger.
Important:
If tool stalls while tightening, DO
NOT raise air pressure above 90 psi. If tools’
air regulator is in low setting, raise setting
and retry.
If nut will not tighten on
maximum setting, do not continue
attempts to tighten nut with this impact
wrench.
Use other methods or tools to
tighten nut.
4.
Release trigger to stop impact wrench.
