Jet J-9225, Инструкция по эксплуатации и каталог запасных частей

Страница: 14 / 28

14
Blade Tension
See Adjusting the proper Blade Tension on page 16.
Limit Switch Adjustment
Refer to Figure 12.
The J-9225 bandsaw should shut off automatically
when a cut is completed. If not, the limit switch
probably needs to be adjusted as follows:
Disconnect the cut-off saw from
its electrical power source.
1. Place the saw in the lowered position to repres-
ent the completion of a cutting operation
2. Using a crosspoint screwdriver and 5/16" wrench,
loosen two mounting screws (A).
3. Position the limit switch assembly (B) to actuate
to the off position as it presses against the back
plate (C) of the control panel when the saw has
cut through the workpiece.
Figure 12