Jet HBS-56MVS, Инструкция по эксплуатации и каталог запасных частей

Страница: 8 / 32

8
5.3 Assembly of Stand
See Figure 5-3.
1. Assemble left (A) and right (B) side plates with
six 5/16x3/4 hex cap screws, twelve flat
washers, six hex nuts (HP2/4/8). Tighten hex
nuts.
2. Turn assembly (from Step 1) on its back (door
opening upward) and mount bottom plate (E)
with two 5/16x3/4 hex cap screws, four flat
washers, two hex nuts (HP2/4/8). Tighten hex
nuts.
3. Install two rubber feet (F) on bottom of left plate
(A).
4. Turn assembly upside down and install wheel
base (D) with four 5/16x3/4 hex cap screws,
eight flat washers, four hex nuts (HP2/4/8).
5. Insert axle (L) through holes of wheel base (D).
6. Install wheel (H) and two 5/8”x30mm flat
washers (HP6) on each side of wheel. Insert
cotter pins (HP7) through holes on each end of
axle and bend the ends of the cotter pins to
secure wheel on axle.
7. Install handle (J) to left side plate (A) with four
5/16x1-1/2 hex cap screws, four flat washers
and four hex nuts (HP3/4/8). Tighten hex nuts.
8. Install door (C). The upper hinge pin is spring
loaded and must be retracted to mount door to
cabinet.
9. Install door lock knob (G) with 5/16 flat washer
(HP4) and 5/16 nylon nut (HP9).
Installation of chip pan (M) is described in sect. 5.5.
Figure 5-3