Jet EQUIPMENT &TOOLS SBR-30N, Инструкция по эксплуатации и каталог запасных частей

Страница: 8 / 20

8
Setting Up the Shear
Do not shear any material
larger than 30” (40”) 20 gauge mild steel.
Failure to comply may cause serious injury
and/or damage to the machine.
1. Install the guide rods and plate in the shear
position (Figure 7) and adjust it to the
desired length of the cut workpiece.
2. Place the workpiece against the block at the
right edge of the table (Figure 8). The end of
the workpiece should be against the guide
plate.
3. Operate the handle to begin the shearing
cut. Shearing action progresses from right to
left.
NOTE: To prevent distortion when notching,
“snap” the handle to facilitate piercing.
Lower Blade Adjustment
The upper and lower shear blades have been
factory aligned and should not require
immediate adjustment. Should re-alignment be
needed in the future, proceed as follows:
1. Place a heavy sheet of paper in the cutting
position, along the entire length of the bed,
and make a cut.
2. If the shear does not cut the paper, loosen
the socket head cap screw (F, Figure 8) at
each end of the table, with an 8mm hex key.
3. Rotate the adjusting screws (G, Figure 9) to
shift the table and change the gap between
blades. Do not allow the blades to
overlap.
4. If the shear cuts the paper on the ends, but
not the center, slightly turn the screw (H,
Figure 10) clockwise until the paper is cut
the entire length.
5. If the shear cuts the paper in the center, but
not the ends, turn the screw (H, Figure 10)
counterclockwise until the paper is cut the
entire length.
Figure 7
Figure 8
Figure 9
Figure 10