Jet EQUIPMENT &TOOLS SBR-30N, Инструкция по эксплуатации и каталог запасных частей

Страница: 6 / 20

6
Assembly
Tools required for assembly:
5mm, 8mm hex keys (“Allen wrenches”)
19mm open end wrench
1. Finish removing the crate from around the
machine.
2. Remove the bolts holding the machine to
the skid.
3. Carefully clean all rust protected surfaces
with a mild solvent or kerosene and a soft
rag. Do not use lacquer thinner, paint
thinner, or gasoline, as these may damage
painted surfaces.
4. Coat all machined surfaces with a very light
film of oil to inhibit rust.
5. Carefully move the shear, brake, and roll to
a work bench or stand. Machine location
must allow free access on all sides.
6. Bolt the machine to a stand or a workbench.
If using a stand, the stand must be bolted to
the floor. If using a work bench, the bench
must be bolted to the floor.
(NOTE: An optional stand is available for
this machine; see page 12. Contact your
JET distributor to order.)
7. Remove one handle (A, Figure 1) from the
operating handle assembly, using an 8mm
hex key.
8. The operating handle can be installed on
either end of the machine. Loosen lock bolt
(C, Figure 1).
9. Slide bar (B, Figure 1) into hub and tighten
lock bolt (C, Figure 1) to secure.
10. Re-install handle (A, Figure 1).
11. Install both guide rods into either the upper
or lower set of threaded holes (Figure 2)
and tighten the setting by rotating the hex
nut against the cast base of the machine
using a 19mm wrench.
NOTE: For brake operation, install the guide
rods into the upper set of holes (Figure 2);
for shear operation, install in the lower set of
holes (Figure 3).
12. Install the guide plate as shown in Figures 2
or 3. Secure it to the rods by tightening the
screws with a 5mm hex key.
Figure 1
Figure 2
(Brake position)
Figure 3
(Shear position)