4.2 Noise emission
Acoustic pressure level (EN 11202):
Idling at maximum speed 73,4 dB (A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of the
hazards and risks involved only.
4.3 Content of delivery
Four way tool post
Set of change gears
MT-2 fixed centre
MT-3 fixed centre
100mm 3-jaw universal chuck
Chuck guard
Splash guard
Digital displays for cross slide
Digital displays for top slide
Assembly kit
Operating manual
Spare parts list.
4.4 Machine Description
Fig 1
A…Change gear cover
B…Emergency stop switch
C…Main spindle drive gear ON/OFF
D…Spindle speed control panel
E…Chuck guard
F…4-way toolpost
G…Cross slide handwheel
H….Top slide handwheel
I….Tailstock spindle clamp lever
J….Tailsock quick lock handle
K….Main switch
L….Overload fuse
M….Longitudinal travel handwheel
N…Half-nut lever
O…Automatic feed lever
P…Lead screw
Q…Tailstock spindle handwheel
5. Transport and start up
5.1 Transport and installation
The machine will be delivered in a
closed crate.
For transport use a forklift or hand
trolley. Make sure the machine does
not tip or fall off during transport.
The machine is designed to operate in
closed rooms and must be bolted to
the cabinet stand or a solid work
bench.
Make sure the machine cannot tip!
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
petroleum, diesel oil or a mild solvent.
Attach the crank handles to the hand
wheels (G, H, M, O, Q J Fig 1).
Mounting machine to stand or solid
workbench.
Unbolt the lathe from the shipping
crate bottom.
Use heavy duty fibre belt for lifting the
machine off the pallet.
Caution:
The machine is heavy (94 kg)!
Assure the sufficient load capacity
and proper condition of your lifting
devices.
Never step underneath suspended
loads.
Carefully place the machine onto the
cabinet stand or a solid work bench.
Bolt together machine and cabinet
stand or workbench.
To avoid twisting the bed, make sure
the setup surface is absolutely flat and
level.
Loosen mounting bolts, shim and
tighten mounting bolts if needed.
The machine must be level to be
accurate.
5.3 Mains connection
Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
10 A surge-proof fuse.
Only use power cords marked
H07RN-F.
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
5.4 Initial lubrication
The machine must be serviced at all
lubrication points before it is placed
into service!
Failure to comply may cause serious
damage.
(see chapter 8 for lubrication)
5.5 Starting operation
Before starting the machine check the
proper chucking (see chapter 6).
Always close the chuck guard and
pulley cover before you start the
machine.
Turn on the main switch (K, Fig 1).
You can start the machine with the
green ON-button (W, Fig 2).
The red OFF-button (X) stops the
machine.
The speed can be adjusted with the
+/-
buttons (R, S).
Use the arrow buttons (U, V) to
reverse the spindle direction.
Only half maximum speed in reverse
direction.
Fig 2