4. Machine specifications
4.1 Technical data
Swing over bed
508mm
Centre distance
800mm
Number of mechanical speeds
2
Spindle speed range 1
0-1200 rpm
Spindle speed range 2
0-3200 rpm
Spindle nose
M33x3,5 DIN 800
Headstock spindle taper
MT 2
Spindle index lock
24x15°, 36x10°
Spindle hole diameter
15,8mm
Tailstock spindle taper
MT 2
Tailstock hole diameter
9,5mm
Tailstock ram travel
115mm
Centre above floor
1120mm
Overall (LxWxH) 1370x690x1470mm
Footprint (LxW)
1270x610mm
Net weight
326 kg
Mains
230V ~1/N/PE 50Hz
Output power
1,5 kW (2 HP) S1
Reference current
10 A
Extension cord (H07RN-F): 3x1,5mm²
Installation fuse protection
16A
4.2 Noise emission
Acoustic pressure level (EN 11202):
Idling 72,5
dB(A)
In operation
78,4 dB(A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the user
to make a better estimation of the
hazards and risks involved only.
4.3 Content of delivery
Casting legs with levelling pads
350 mm tool rest
75 mm face plate
Spur centre and tooling knockout bar
Live centre
Guard
Tool caddy
Comparator centers
Remote ON/OFF switch
Operating tools
Assembly kit
Operating manual
Spare parts list.
Fig 1
5. Transport and start up
5.1 Transport and installation
The machine is designed to operate in
closed rooms and must be placed
stable on firm and levelled ground.
The machine can be bolted down if
required.
For packing reasons the machine is
not completely assembled
5.2 Assembly
If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with a
mild solvent.
Attach the leg stand:
At this point the headstock, tailstock
and tool rest should be removed.
The machine bed is heavy! With the
help of a second person, carefully lift
bed up onto a workbench.
Attach the leg stand with 8 hex socket
cap screws and 8 flat washers (A, Fig
2).
Fig 2
Thread adjustable feet (D) into stand
leg (B).
Adjust the feet so that the lathe rests
evenly on the floor, and tighten the
nuts (C).
Reinstall headstock, tailstock and tool
rest.
Tool caddy assembly:
Mount the tool caddy with two screws
and lock washers to the left leg (Fig 3)
Fig 3
The tailstock body can also be used to
store tools (Fig 4).
Fig 4
Stand shelf:
You can make an extra shelf that rests
between the legs if you wish (Fig 5-7).
