Jet-tech 727, Руководство пользователя, Страница: 17 / 28

RINSE PUMP ADJUSTMENT AND PRIMING
• The rinse pump is standard equipment on all JET-TECH machines and automatically injects rinse additive into the rinse
water for the final rinse.
• The rinse pump is located in the base of the machine. The front, lower panel (below the door) snaps off to access the rinse
pump. Cut the cable tie, route the tube out from the base of the machine and drop the clear vinyl hose and filter into your rinse
additive container. (F1 8 & F1 8DP models are supplied with a rinse additive bottle that fits inside the base of the machine)
Adjustments should be made clockwise to reduce the amount of rinse additive and counter clockwise to increase the amount
of rinse additive.
• If air gets in the rinse hose or if the pump stops drawing additive
from the container, the pump may need to be primed.
1) Turn OFF the machine and empty the wash tank.
2) Turn the adjusting screw on the rinse pump approximately 10
turns counter clockwise. The screw may fall out but this is not a
problem. Just remember how many turns you had made when the
screw fell out.
3) Turn the machine ON & OFF, ON & OFF, ON & OFF, ON &
OFF, etc., until the liquid is drawn up the tube to the rinse pump.
4) Turn the adjusting screw on the rinse pump 10 turns clockwise or
the same amount of turns you had made when the screw fell out.