10
ATTACHING THE TA FENCE TO A NON-JESSEM TABLE TOP
You will need to source eight (8) Wood Screws. The length of the screws will depend on
the thickness of your table top. Typically you would want screws that are about ¼” less
than the thickness of your top. (Example: 1” Table top would require ¾” screws.)
STEP 1:
Marking your holes
a.
b.
Figure 17
Figure 18
Figure 19
With a pencil, mark your holes
on the underside of
your
table top
,
using the fence angle
/track
assembly
as a template.
See
Figure 18.
You will
want to have the back of the track close to even
with the back of the table top
as shown
i
n
Figure
19.
Take one of your preassembled fence track and
angle
assemblies and e
nsure the angle is fairly
c
e
ntered against the track. See
Figure 17
.
Fence Angle Fence Track
Pre-drill the holes using a 1/16” diameter drill bit
and be sure you do not drill through the table top
surface.
It is suggested you use
masking tape
on
your drill bit to prevent this.
STEP 2:
Drilling Your Holes
and Securing the
track assembly to your table top
Secure the track mount to the table top with the #10
wood screws you sourced. Repeat this step for the
other side. See
Figure 19
.
Flip your table top over and return to
STEP 2
on
Page 6
and follow the instructions for adjusting
the height and
front to back alignment of your
tracks on
your
TA Fence.
e.
You will want to have roughly the same amount of
space from each end of the fence angle to the
outer edge of the fence track
before
proceeding to
S
tep b.
Back of table top should
be flush with back of
fence track
