The Mite-R-Slide II is calibrated in our factory prior to shipping. You should not have to
make any adjustments to the tool. If you find the gauge is not calibrated to
0° or
45°
precisely please follow these instructions.
STEP A:
Set the gauge to 0° and then place a square against your router table fence.
See
Figure 19 and 20
. If your Mite-R-Slide II square is not perfectly square
you will see a gap towards the front of your router table or a gap closer to
the Router Fence.
STEP B:
Ensure the gauge is set at the
"
0
°
".
Loosen the Mite-R-Slide II fence clamping knobs
(Part #42)
, See
Figure 21
and slide the Mite-R-Slide II fence
(Part #4)
toward
s
the front of the table to expose the first set
screw
(Part #41).
See
Figure 21.
FIGURE 19
FIGURE 20
FIGURE 21
FIGURE 22
9
MITE-R-SLIDE II CALIBRATIONS
CALIBRATING FENCE TO “90°” or (“0°” on the gauge)