FIGURE
1
4
STEP 1
2
:
Slide
the Left
Hand
Stop
(Part #1
7
) into the t-track on the
left side of the fence
.
See
Figure 14
.
STEP
10
:
Take the
Right
Hand
Stop Base
,
(
Part #
22
)
and slide it into the t-track on the top of your fence. See
Figure
12.
STEP
1
1
:
You will want to have the
stop
sitting flush with the
right
edge of your fence. See
Figure
13
. Tighten the
1/4-20 x
5/8"
stainless steel cap screws
Part #
7
with the provided 3/16" hex key.
FIGURE 12
FIGURE 13
FIGURE
1
5
STEP 1
3
:
Slide the Mite-R-Slide II along the router table fence to where
you
would desire the end of cut to be. This
is to ensure
the fence goes
all the way past the cutter if you are working on the edge of a board
or at some point before this for blind cuts.
Slide
the Left
Hand
Stop
a
long the track
until it meets the rollers on
the Mite-R-Slide II roller base. See
Figure 15
. Tighten the 1/4-20
x 5/8" stainless steel cap screws Part #
7
with the provided 3/16"
hex key.
7
