FIGURE 5
FIGURE 6
MOUNTING THE MITE-R-SLIDE II TO YOUR JESSEM ROUTER TABLE FENCE
STEP
7
:
Slide
the gauge and roller assembly put together in Step 5
and Step 6
onto the fence. Ensure the
retaining bolt
(
Part #
25
)
on the bottom of the roller
assembly slides
into the t-slot on the top of the fence.
See
Figure 5 and
Figure 6
.
STEP
8
:
Take one (1) sheet of
regular sized
paper and fold it in
half, and then in half again
so it has a thickness of four (4)
sheets of paper.
Slide it under the fence closest to the the
Router table fence.
See
Figure 7
.
STEP
9
:
NOTE:
When adjusted correctly, your Mite-R-Slide II fence should be
slightly
off of the table surface closest to the
fence and riding on the table surface at the end closest to the front of the router table. See
Figure 9, 10, 11.
FIGURE 7
FIGURE 8
FIGURE 9
5
While holding the Mite-R-Slide II fence to the paper spacer
and keeping the roller mount (Part #1
8
) with the rollers
fully engaged into the router table fence, securely tighten
the 1" stainless steel cap screws (Part #
8
) you installed in
Step 5 and 6. See
Figure
8
.
