JESS WELDING inoMIG 350, Руководство по эксплуатации

Страница: 73 / 112

inoMIG 350/400/500 8 Overview of control functions
BA-0014 • 2020-06-05
EN - 19
8 Overview of control functions
8.1 Welding
To ensure high-quality welding, it is important to select the correct welding voltage step and, based on this,
the best possible wire feeder speed and gas volume.
1
Adjust the pressure regulator: Set the required shielding gas volume using the pressure regulator
(6–18 l/min). The required gas volume largely depends on the strength of the welding current.
2
Insert the welding wire: select the welding wire based on the material that is to be processed.
Use a suitable correct contact tip and wire feed roller for the welding wire.
 See 9.1 Control functions on page EN - 20
3
Adjust the wire feeder speed.
 See 9.1 Control functions on page EN - 20
4
Start the welding process by pressing the torch trigger.
Tab. 5 Overview of MC1 and MC2 control functions
Functions MC1 MC2
Inverter system ■ ■
Manual mode ■ ■
Automatic mode ■ ■
Arc length correction ■ ■
Material selection ■ ■
Power can be individually adjusted ■ ■
MIG mode ■ ■
TIG mode – gas pre-flow time and slope-down time adjustable ■ ■
2-step, 4-step, spot ■ ■
Crater filling – Hotstart – reduce ■
Save/delete individual jobs (max. 100) ■
Gas test ■ ■
Feeding in the wire ■ ■
Coolant flow display ■
Minimum coolant flow adjustable ■
Power selection based directly on material thickness ■ ■
Creep (StS) adjustable ■ ■
Wire burn-back (bUb) adjustable ■ ■
Gas pre-flow time (PrG) adjustable ■
Gas post-flow time (PoG) adjustable ■
Spot time (SPt) adjustable ■ ■
Throttle strength can be individually adjusted ■ ■
Remote control functions adjustable ■
Welding cable lengths adjustable ■
Water pump On/Off ■
Machine type adjustable ■
Software update for curves ■ ■
Lock/unlock control system (CODE) ■
Fan/water pump (where relevant) regulated ■ ■
Display HOLD time adjustable ■ ■
Reset control system to factory settings ■ ■